STANDARDS & FORMULAS

Shop Drawing for Power

Shop Drawing for Power works with Shop Drawing for Lighting: they share these references. Lighting circuits wired on the plan: conduit routed from the panel to every fixture, nearest to nearest, checked against its own fill limit.

Standards and regulations

  • IEC 60364-5-52
    Low-voltage installations - wiring systems

    The conduit’s size and fill limit for the circuit it carries.

Formulas

Conduit fill

fill = Σ (π d² / 4) / (π D² / 4) ≤ 40 %

  • d = each cable’s outer diameter
  • D = the conduit’s inside diameter

Design rules it applies

  • Conduit routed from the panel to the nearest fixture, then the nearest one from there
  • A way split into two when it would overfill the conduit

For reference. MO.tool works these out to help your design; the engineer remains responsible for it. Always check the edition of each standard your project uses and the requirements of the local authority (DEWA, ADDC, Civil Defence…).

Back to Shop Drawing for Power